Step-By-Step Assembly Instructions
Step 1 – Install each leg and lock it into place by
tightening the knob.
Make sure that you have a level surface to assemble your machine.
Place each leg onto a square leg receiver with the knob-nut on top.
Slide the leg as far onto the receiver as it will go. Place a knob
into each leg and tighten it until the leg is locked securely in place. Check each leg to insure that it is tight and does
Step 2 – Put the height adjustment collar onto the
axle and tighten the knob.
The axle is shipped inside the support column and must be pulled
up to slide the height adjustment collar onto it. Place two fingers inside
the axle and pull it up at least 6 inches. Slide the collar onto
it and tighten the adjustment knob locking the collar securely into place.
Step 3 – Apply heavy duty wheel axle grease to the
machine’s axle for lubrication.
To lubricate the axle, grab the top component and pull the axle
up and out of the machines’ support column. Apply grease to the axle below the height adjustment collar. Spin the top
completely around several times to evenly spread the grease. Carefully
slide the axle back into the support column. Always leave your axle inside the column. The grease used for this application
is the heavy-duty wheel axle grease that can be purchased at any
auto parts store or automotive section of any mass merchant store.
If you would like more tension, knots can be tied on the powerbands
to adjust the height. Slide the plastic ball on the cord and tie another knot. Now slide the ball over the knot.
Step 4 – Install the machine’s top component
and tighten knob to lock it onto the top end of the axle.
Slide the top component down onto the top end of the axle. The top
component is the part of the machine that holds the ball unit in place. It has the Hurricane decal on both sides. Put an adjustment
knob into it and tighten the knob securing the top component onto the